DCC++ & LokSound Keep-Alive Workbench Archive
Experiments and demonstrations from Kelby’s workbench, including the original DCC++ system, Raspberry Pi control and an early LokSound/TCS Keep-Alive installation.
Browse all DCC chapters
For choosing a decoder or fixing a locomotive, start with the DCC Decoder Guide.
From Kelby’s Workbench: 2017
These recovered posts preserve examples of what was working at the time. Their prices, software versions and wiring details are historical. Use the current documentation below when building or modifying equipment.
- February 22, 2017 — DCC++ introduction. Kelby described an Arduino Uno/Mega and motor-shield setup with JMRI, phone throttles and CV programming. Original DCC++ post.
- February 22, 2017 — LokSound with TCS Keep-Alive. An HO Southern Pacific tunnel motor was demonstrated with an ESU LokSound decoder and a TCS WOW motherboard with Keep-Alive, running on DCC++. The post does not identify the exact board or decoder revision, so this example cannot establish a universal wiring recipe. Original installation video post.
- March 2, 2017 — Raspberry Pi, JMRI and WiThrottle. Kelby showed a 7-inch touchscreen on a Raspberry Pi running JMRI, with wireless control through WiThrottle. The Pi and screen were optional additions to the DCC++ setup. Original Raspberry Pi demonstration.
The original Facebook posts may require group access. The technical summaries above can be read without Facebook. For publicly available reviews, visit the SPT video archive.
Building a DCC++ or DCC-EX System
The original DCC++ BaseStation used an Arduino and motor shield to generate track commands. It made an inexpensive experimentation and bench-programming platform possible, and it is the system shown in Kelby’s 2017 posts.
For a new build, start with the current DCC-EX EX-CommandStation instructions and supported hardware combinations. JMRI identifies Classic DCC++ as unmaintained; its DCC++ connection page directs users to the DCC-EX connection, including for older DCC++ hardware. Old screenshots and menu names may no longer match.
What Each Part Does
- Command-station controller: runs the firmware that generates DCC commands.
- Motor driver or shield: provides the electrical track output. Its current sensing and limits matter.
- Power supply: must suit the board, decoder voltage requirements and intended load.
- JMRI computer or Raspberry Pi: can provide programming tools, a roster and a throttle server. It is separate from the track-power hardware.
- Phone or physical throttle: provides the controls. The connection route depends on the command station and network configuration.
A Raspberry Pi touchscreen is optional. Kelby’s original setup used the Pi to run JMRI and connect a WiThrottle phone. JMRI continues to support Raspberry Pi installations and several throttle interfaces, but follow the current installation instructions for the selected operating system.
For phone control, use JMRI’s WiThrottle setup guide. It explains the JMRI throttle server and compatible phone apps. For computer installation and DecoderPro, follow the JMRI guides on our DCC page.
Build and Test in Small Steps
- Select a documented controller, motor driver and firmware combination.
- Follow that motor driver’s exact jumper, power and current-sensing instructions. Do not transplant an old Uno diagram onto a different Mega or shield.
- Confirm the required power supplies and track-voltage limits before connecting the locomotive.
- Connect a small MAIN test track and a separate, electrically isolated PROG track as documented.
- Prove basic operation with one known-good locomotive and a direct supported control connection.
- Add JMRI, wireless throttles and the touchscreen after that baseline works.
The correct motor-driver profile matters for protection and programming acknowledgements. A higher-current power supply does not increase a shield’s safe output rating. For expansion, plan supported boosters or districts rather than joining independent outputs together. Read the DCC-EX motor-driver configuration and power-supply guidance.
Watch the SPT locomotive reviews on YouTube · Back to the DCC guide
About South Plains Trains · Suggest a correction or ask a DCC question